AG Engineers is a leading manufacturer of V Belt Drive Pulley in Junagadh. A flange is a small but critical tool in a synchronous pulley system. In applications where consistency is absolutely critical, flanges play an invaluable role in operational stability and preventing misalignment.
Like the best suppliers of V Belt Pulleys, Idlers in Junagadh, pulley flanges are small rings attached to the pulley and located on either side of the teeth. A pulley runs between each flange to hold the belt firmly in place. The flange is important because the belts tend to follow one side or the other, which is called offset. We offer the best V-Belt Pulleys for Taper Lock Bushes in Junagadh.
As experienced Exporters of Industrial V-Belt Pulley in Junagadh, pulley flanges are a suitable method of belt tracking for most timing belt drives and conveyor systems. The V-Belt Pulleys & Sheaves hold the belt on the pulley, resisting lateral forces that pull the belt to one side or the other. The flanges are fixed to the pulleys by rolling or by screws, depending on the tooth profile and the diameter of the pulley. Small and medium pulleys with a diameter of approximately 250 mm are usually supplied with rolled flanges. Large pitch pulleys such as T20, AT20 and XH are usually supplied with flange screws. The use of flanges on V-Belt Pulleys in Junagadh is essential for proper belt tracking in timing belt drives and conveyor systems. These flanges securely hold the belt on the pulley, preventing any lateral forces that could cause the belt to shift to one side or the other. The method of attaching the flanges to the pulleys varies depending on factors such as tooth profile and pulley diameter. Smaller and medium-sized pulleys, around 250 mm in diameter, typically come with
Pulley tracking with Flanges:
